Thread Rating:
  • 1 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Advanced C&E
#11
(11-04-2019, 11:13 PM)Mr C Wrote:
(11-04-2019, 09:51 PM)Senator Wrote:
(11-04-2019, 08:07 PM)Mr C Wrote:
(11-04-2019, 07:04 PM)Senator Wrote: Hi all.

I've a mx4 panel and they want to be able to switch cause and effect.

Basically it's one out all out but when a keyswitch is turned it changes to pulsing for 240 seconds and then evac.  Double knock all out.

Turn keyswitch off and it's back to one out all out.

I haven't looked at it yet but was wondering if anybody had any idea how it could be achieved. 


Thanks in advance.

Easy enough in relevant output group:


 zone 1-1000 fire ringing style o,

 then add a logic statement of any fire AND  keyswitch (setup key switch as a control signal)ringing style 1 (setup style 1 phase 1  on off pulse phase 2 240 seconds then on).

then add 3rd line any 2 device fires style 0

that should be it

Just thought do you want MCP to over ride pulsing/delay? If no then change all MCPto category B fire otherwise a mcp will be treated as a double knock when the key switch is on

Thanks Mr C. Just had a look there. The only issue with what you said is that while keyswitch is on I Will have to turn off the first line ie zone 1-1000 ringing style 0
Sorry yes you are right as Royce said swap it round the other way.

That was a deliberate mistake of course just to make sure you were awake..... well done for spotting it  Biggrin Biggrin

Did that job today and it worked a treat. Many thanks for the assistance. A rep point on the way.
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Advanced mxpro 4 intermittent open circuit jordanjor 8 749 09-10-2019, 04:43 PM
Last Post: MD Martin
  EM Vents - Advanced MxPro5 Next4467 7 1,053 29-08-2019, 02:30 PM
Last Post: Next4467
  Advanced disablement via keyswitch input alonso 2 532 30-07-2019, 06:50 PM
Last Post: Mr C
  Advanced call point delays Bero 2 636 11-06-2019, 02:25 PM
Last Post: sparky999
  ems and advanced Advel Tech Support alonso 14 1,913 06-03-2019, 12:55 AM
Last Post: dubfireengineer
  High resistance loop advanced mx pro 5 dcarney 18 6,684 05-05-2018, 09:09 PM
Last Post: Monkeh
Rolleyes Advanced Mx config output evac Bero 4 1,607 04-04-2018, 10:28 PM
Last Post: Graeme
  Advanced loop card short circuit testing xenex100 60 33,764 06-03-2018, 10:07 PM
Last Post: Monkeh
  Advanced MX Software Service Tools Midpat Fire 5 2,483 28-02-2018, 11:59 PM
Last Post: Tilly
  Advanced diagnostic mode logs luggsey 22 7,044 09-02-2018, 12:12 AM
Last Post: sparky999

Forum Jump:


Users browsing this thread: 1 Guest(s)